Description
BE13240-G - PNEUMATIC LOW-PRESSURE SWITCH - 55 PSI, 12/24V
PART NUMBER(S):
Fleet Products: BE13240-G (New) | Replaces OE: Haldex: 13240A | Bendix: 13240 | Automann: 170.13240, AM17013240 | WABCO: 8940416082, 894-041-608-2, 894 041 608 2 | Dana: 222054 | Mack: 1MR2225, 5396-BE13240, 5396BE13240 | Volvo: 571427A | Freightliner: HDX BE13240, TDARBE13240 | Genuine Newstar: MIR-BE13240, S-21903, S21903, S-A266 | Midland: BE13240, MID13240, MID13240A, MP13240A, PA13240A, TE13240 | Meritor: RBE13240, RMP13240A, R955BE13240N | PAI: 3606, 36060, EM36060, EM-360600, EM360600, LST-3606, LST3606 | Tramec Sloan: 401238, 401241 | Tectran: 14-3240, TV13240, TV13240TEC | NAPA: BE62021, MBIBE13240 | World American: WA13240 | OTR: AV13240
DESCRIPTION:
Model: Haldex BE13240 LP-2 Pneumatic Low-Pressure Switch
Vehicles: Freightliner, Volvo, Mack, International, Kenworth, Peterbilt, and other heavy-duty vehicles with compatible pneumatic warning circuits
• Switch Type: Pneumatically actuated, single-pole, two-terminal pressure switch
• Actuation Pressure: 55 PSI
• Circuit Position: Normally closed at zero pressure
• Electrical Terminals: Two
• Pneumatic Port: One 1/8"-27 NPT
• Operating Voltage: 12/24 VDC
• Function: Changes electrical circuit position when system air pressure crosses the specified 55 PSI threshold
• System Use: Low-air-pressure warning light and related pneumatic brake warning circuits
Applications:
Designed for heavy-duty vehicle air brake systems requiring a normally closed low-pressure switch with a 55 PSI actuation point. It is typically replaced when the low-air warning remains active at normal pressure, fails to activate during a pressure loss, changes state at the wrong pressure, or develops an air or electrical fault.
CROSS-REFERENCE(S):
143240, 14498, 170.1324, AS266, AVBE13240, BE13240MID, BE13240PTP, HBSBE13240, KBE13240, M13240, RB13240, 13240SA
A cross-reference listing means this part may be a suitable replacement for the listed part numbers. Always verify fitment before installation.
IMPORTANT INSTALLATION NOTES:
✔ Fully drain air-system pressure before removing or installing the switch.
✔ Apply pneumatic-grade thread sealant to the 1/8"-27 NPT connection without allowing sealant to enter the switch.
✔ Confirm the system requires a normally closed, two-terminal switch with a 55 PSI actuation point.
✔ Connect the two electrical terminals according to the vehicle wiring schematic.
✔ Pressurize the system and verify correct warning-circuit operation above and below 55 PSI with no air leakage.
Warranty Information
